Kvaser_PCcan_HS

友情提示:(1)有问题: 可以点击 右边中-在线咨询,左侧qq,旺旺在线联系
         (2)感兴趣: 可以点击 左侧中-分享到

 

Kvaser PCcan HS

 

Hardware

  • The board is a quarter-size (length 135 mm) 8-bit ISA bus board and occupies 64 bytes of I/O space. The base address can be any of 200H, 240H, 300H, and 340H. The interrupt signal on the CAN controllers can be connected - under software control - to any one of IRQ 2/9, IRQ 3, and IRQ 5 on the ISA bus.
  • The original 16 MHz oscillator may be replaced with an oscillator of frequency range 1-24 MHz to obtain the required bit rate on the bus. The PCcan 4xHS board draws approximately 600 mA at 5V.
  • The industry-standard CAN controllers on the PCcan cards are directly accessible to the programmer. This makes the cards suitable for cross-platform development: you can develop your software on your PC and then move it, with a minimum of changes, to your embedded system.
  • The CAN controllers support CAN 2.0 A and 2.0 B (active.) The CAN bus drivers supports the standard, high-speed ISO11898 physical layer.

External Connector

  • The outputs from the CAN circuits are connected to female D-SUB connectors via optocouplers and bus drivers (Philips 82C251, conforming to ISO 11898).
  • The connectors provide the voltage feed for the bus section (optocouplers and driver circuits). Alternatively the PC is used as power source; however this gives no galvanic separation between the computer and the CAN bus.
  • On the PCcan 4xHS card, it is possible to connect all the 4 CAN in/outputs to a common CAN bus, which is also connected to the CAN-connector.