UserCase Vedio

imulation platform for RCP motor as shown below

  ER-Sim can be downloaded Matlab application to the appropriate corresponding program running on the CPU board，which can

achieve real-time simulation of the requirements.
· ER-Card-PWM12, motor control panel
· Modular Cartridge way
· PWM12 output, 6-phase, high-side, bottom output
· process control dead time delay
· You can set the center-aligned and edge-aligned
· Under-driven applications to provide basic matlab interfaces, including interface module SVPWM
· up to do PWM24, 12-phase motor
· need to customize with more than 12
· external fault input, 1Ch, corresponding to a group PWM12  
   It can provide an AC motor control, providing 6-phase motor control (PWM channels can increase the number of demand), to provide each phase of the bridge high and low drive signals. Provide fault protection input signal, in the event of failure to protect the state of the PWM output.
Motor driver
Motor drive using the basic two-level phase-driven approach, using IGBT driver. Basic parameters are as follows:
· cable input, output terminals
· IGBT drive
· itself with 2-phase current detection
· itself with bus voltage detection
· 1 set of 3-phase motor current output
· do AC permanent magnet synchronous motor, permanent magnet AC induction motor, brushless DC motor drive

· Input signal Isolated

Motor TestBench
· Eddy loader power, 2 ~ 10kW
· eddy current load control: ± 10V control
· torque and speed sensor: 20Nm, output 4 ~ 20mA or 0 ~ 5V
· test platform: custom